NEW Easton RX7- The Ultimate Indoor Recurve Arrow Shaft

Easton’s exclusive tapered technology allows a bigger line-catcher arrow at lower bow and point weight

New for the 2020 indoor season, Easton announces the most accurate, technically advanced indoor arrow shaft ever devised for recurve finger shooters- the all-new RX-7 series.

Available in three spine values- 525, 475, and 420- in a 21, 22, and World Archery Maximum 23 diameter.

Easton’s new RX-7 series 7178 aluminum arrow shafts incorporate a precision rear taper – effectively letting recurve shooters shoot a bigger arrow at a lower bow weight, and also with less point weight, while maintaining maximum shaft diameter for higher scoring potential.

Proven in the 2018-19 competition season by some of the top archers in the world, including Team USA’s Brady Ellison and Jack Williams, the RX-7 is based on the same proven design principle as Easton’s X10 and A/C/E shafts, with the precision flexible, forgiving rear taper.

The rear tapered design element drops the dynamic spine of the arrow shaft by up to one full size, which allows the use of a larger diameter and lighter point.

Until now, many shooters seeking maximum diameter arrow shafts often needed to compromise the bow tune, and potentially compromise shooting technique forgiveness, by using super-heavy points, leading to greater error potential with slight natural release inconsistencies.

By using a normal weight point, and a precision engineered, more flexible rear taper with a weight-forward design, RX-7 series shafts provide the ultimate in finger release forgiveness. RX-7 uses full-strength 7178-T9 alloy that easily copes with tough European target materials.

RX-7 shafts are supplied with Easton Super-UNI bushings, which accept available Easton Super Nocks, 3D-Super Nocks, and the popular size 19 Beiter nock.

The RX-7-23 uses any Easton 2315 point, the RX-7-22 uses any Easton 2214 point, while the RX-7-21 takes any Easton 2114 point. These same sizes also can be used to select the rear nock UNI-bushing or certain Beiter insert nocks.

The updated tuning chart for the RX-7 is available clicking on "MANUAL"

RX-7 shafts are 100% Made in the USA.